Download the drivers

• The drivers can be downloaded from the Support website.
• Scroll down to Download the Software and drivers.
• Click Request access download Center.
• Fill in the form and click Send your request.
  You will receive all the info to download the software and drivers.

Install the drivers

• Once you have installed the IRISPen software, double-click the IRISPen shortcut on the Desktop.
  When you start the IRISPen for the first time and you haven't connected the pen yet, you are prompted to do so. The IRISPen Air can be connected in two ways: via the provided USB cable or via Bluetooth.

Via USB cable:

• Plug the IRISPen in a free USB (2.0) port. When you do this for the first time, the driver is installed automatically. When the installation is complete a balloon message appears in the bottom corner of the Desktop.
• Press the scanning tip for 3 seconds to power on the pen.
• When you connect the IRISPen for the first time, the IRISPen Tour is started automatically.

Via Bluetooth:

• On Windows: insert the provided dongle into a free USB (2.0) port.
• On Mac OS: the dongle is not compatible. Note that the IRISPen Air supports Bluetooth 4.0 and higher.
  It is not compatible with older versions of Bluetooth.
• Press the scanning tip for 3 seconds to power on the pen.
• The blue Bluetooth led blinks slowly while the pen is being paired to your computer.

Notes:

The pairing does not require a password.

The pairing may take some time to complete.

• When the Bluetooth connection has been established the blue led stays on.

Note: in case the IRISPen is connected but you don't see it on your device, make sure it is not connected to another device nearby.

• When you connect the IRISPen for the first time, the IRISPen Tour is started automatically.